In short
If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Mendham realigns or replaces the sensors and tests the safety reverse.

Doors that won't close in Mendham
In Mendham Borough, the Main Street historic district and the surrounding streets have 18th- and 19th-century houses with barns and carriage sheds, where floors are uneven and sensors never quite line up. In the Township, estates and horse farms have large multi-bay garages and outbuildings with long wire runs, dust and mice. Around Ralston and the Roxiticus area, wooded hills and long gravel or paved drives bring grit and leaves to the threshold. Winters in the Somerset Hills are colder than closer to the city, and frost heave tilts slabs, leaving one sensor higher than the other.
Why a garage door refuses to close
- Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
- Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
- Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
- Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.
Three safe checks before you call
- Look at the small lights on both sensors. Each should be on and steady.
- Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
- Gently turn the blinking sensor until its light goes steady, then try the remote again.
If that doesn't do it, stop there. Don't tape the sensors together or bypass them.
How the repair is done
The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.
Around Mendham
- Ralston: A historic hamlet in the township with older homes.
- Roxiticus area: Country roads near the golf club with large homes.
See the full Mendham service area.